Ulvac DC-10-4P, Руководство по эксплуатации

Страница: 92 / 103

DC Puse Power Supply
【
DC-10-4P
】 8 APPENDIX
80
Command Transmission data Acknowledgment data
Command Command name Capacity Description Capacity Description
0x16
IGNITION
VOLTAGE
2byte
Set the ignition voltage of the power supply.
It can be set in the range from 800V to 1,500V in steps of 10V.
1byte STATUS
0x18 Master Reset Reset ERROR occurring in the power supply. 1byte STATUS
0x1C RAMP MODE 1byte
0x00 : DISABLE
0x01 : ENABLE
1byte STATUS
0x1D RAMP TIME 2byte
This is the setting of the rise time from START to the set value
(Level).
This can be set in the range of 0.05 to 600 seconds.
5(0.05 second)
：
0x0005.
60000(600 second)
：
0xEA60
1byte STATUS
0x1E RAMP START 1byte
This is the starting value (Level) for starting Ramp operation.
This is set by the percentage with respect to Level.
0
～ 100%
100 ： 0x64
1byte STATUS
0x20 POWER LIMIT 2byte
The limit of the output power can be set.
The limit value depends on the composition of the connected
power supplies.
0
～ 60.0 kW → 600
600 ： 0x0258
1byte STATUS
0x21 VOLTAGE LIMIT 2byte
The limit of the output voltage can be set.
The limit value depends on the power supply model.
0
～
800V
800
：
0x0320
1byte STATUS
0x22 CURRENT LIMIT 2byte
The limit of the output current can be set.
The limit value depends on the composition of the connected
power supplies.
A value 10-hold larger than the desired set value.
0
～
15 0.0A → 1500
1500
：
0x05DC
1byte STATUS
0x24
PULSE
PARAM SELECT
1byte
Two types of parameters (SET_A, SET_B) related to ARC
and pulse oscillation shown below can be set.
If each parameter is changed, the data is stored in the active
SET.
This command switches between SET_A <-> SET_B.
SET_A
：
0x00
SET_B ： 0x01
The parameter that can be switched:
・ 0 x25 DCMD ARC SHUT DOWN TIME
・
0x2B ARC SHUT DOWN VOLTAGE
・ 0x2C ARC SHUT DOWN CURRENT
・
0x42 PULS CYCLE
・ 0x43 PULS WDTH
・
0x45 PARC_OSON (1ST
、
2ND
、
ENBL)
・ 0x46 PULS HARD ARCJGE
・
0x48 PULS HARD JDGE COUNT
・ 0x49 PULS HARD SHUT DOWN TIME
1byte STATUS