Ulvac DC-10-4P, Руководство по эксплуатации

Страница: 37 / 103

DC Pulse Power Supply
【
DC-10-4P
】 4 DESCRIPTION OF FUNCTIONS
25
No. Name Shape Function
⑫
OLED display
Display
Set output values, output values, and various parameters appear.
⑬ LED
LED (Green)
SETPOINT
This lights up when the output reaches the set value.
LED (Green)
READY
This lights up when there is no FAIL with the
interlock released.
LED (Green)
INTERLOCK OK This lights up when the interlock is released.
LED (Orange)
ARC
This lights up when an arc process is carried out.
LED (Red)
FAIL
This lights up when an error occurs.
⑭ Insulated bush Bush
Insulate the housing when attaching the unit to a rack.
4-1-2. DC power back panel
①
②
③
④
⑤ ⑤
⑨ ⑧ ⑦ ⑩
⑪ ⑫ ⑬
⑥
⑭
Figure 4-2: Back of Power Unit
Table 4-2: Name and function on back of power unit
No. Name Shape Function
① AC INPUT Connector
Connector for AC input
② Name plate
－
Indication of Model, S/N, etc.
③
DC OUTPUT Connector
Connector for DC output
④
USER IO PORT D-sub 37-pin connector Connector for external control
⑤
Ground terminal M5 stud Enclosure ground terminal* 1
⑥ Breaker Circuit breaker
The AC input is supplied to the power supply or shut off.
Upper: supply; Lower: shut off
⑦
M/S configuration
switch *2
Rotary switch Before Master/Slave operation, make the settings.
⑧
M/S connector (female) D-sub 15-pin connector Before Master/Slave operation, make connections.
⑨ M/S connector (male) D-sub 15-pin connector Before Master/Slave operation, make connections.
⑩
SERIAL communication
port
D-sub 9-pin connector Use in the RS232C/RS485 communication mode.
⑪
P configuration switch*3 Slide switch
This is not used. The factory default setting is the N side.
⑫
USB connector*3 USB
This is not used.
⑬
Mode configuration
switch*3
Piano switch
This is not used. The factory default settings are all in the
upward direction (on the OFF side).
⑭
Optical synchronization
connector Optical connector Make a connection for checking the pulse synchronization
operation.
*1 When using an optional input cable, the connection of an earth wire to the terminal is not necessary. Install the unit with the
earth wire on the input cable side.
*2: The respective switch position depends on the number of connected M/S units. See Section 【 3-4-3.M/S settings 】 .
*3: This is used for maintenance. Do not make any
settings
. If the setup content is changed, the power supply unit cannot be
started up normally.If any changes are made accidentally, reset to the factory default settings.