Siemens HiPath 3000 V3.0 or later Gigaset M1 Professional, Руководство по обслуживанию, Страница: 975 / 1202

service.fm
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
12-13
Service
Service and Maintenance Tasks
Procedure
Notes on the APS transfer sequence
●
If the transfer connection is interrupted (due to a line interruption, for example), the entire
APS transfer must be manually restarted via HiPath 3000 Manager E. The complete APS
transfer is performed again.
●
Since the software is written to the MMC in compressed format during APS transfer, it must
be unpacked after the transfer is complete (this takes about 5 minutes).
●
After the APS transfer, the checksum is analyzed. If errors are found in the checksum, de-
lete the transferred APS. You then have to repeat the complete APS transfer.
●
Once the APS has been successfully transferred, the message "APS transfer was suc-
cessful" appears. You can then finish the session.
●
The system software uses a special system reset (none of the other resets initiate a
changeover) to change over to the new APS.
You cannot use the telephone while the system resets and boots up.
Step Activity
1. Save the existing customer data (for example: as "customer1.kds").
2. Select “Open CDB” from the HiPath 3000 Manager E file menu and highlight
“APS files (*.fst)”.
Open the fst file using the new system software.
3. Double-click the “Transfer” icon:
Select the appropriate access and enter the PIN code.
4. Highlight “APS Transfer”. A new window appears in the top right of the screen.
You can use this window to select whether
●
to change directly to the APS after the transfer is completed.
●
to change to the APS at a pre-determined time.
Note: If the “APS Transfer” field has a gray background, then the fst file was
not opened correctly.
5. Start the APS transfer. Transfer time for connection via digital modem (ISDN)
or LAN is approximately 20 to 30 minutes. Connections via the IMODN analog
modem or direct connections (V.24 interface) require longer transfer times.
6. Once the APS transfer is completed, the HiPath 3000 Manager E reports that
the “APS transfer was successful”. Once the set transfer time has been
reached, the system resets and the new version is used for startup.
7. Use the “ APS stamp ” to verify that the new APS has been activated. Use Hi-
Path 3000 Manager E or Assistant T (menu item 29-1-2) to make the neces-
sary query.