Siemens HiPath 3000 V3.0 or later Gigaset M1 Professional, Руководство по обслуживанию, Страница: 637 / 1202

inst_h3.fm
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
4-159
Installing HiPath 3000
Installing HiPath 3750, HiPath 3700
The figures below show the PCM segments (64 time-division multiplex channels each) for the
different HiPath 3750 and HiPath 3700 system configurations.
Single-cabinet system: PCM segments
7
Caution
The following board assignment rules must be observed to ensure that the system
works properly and without blocking:
●
SLC16N
– Maximum SLC16N per PCM segment. The SLC16N should be configured
alone on the PCM segment, where possible.
– Note the following information on the subject of multi-SLCs: “SLC16N board
distribution in HiPath 3750 and HiPath 3700 cabinets” on page 3-156.
●
IVML8, IVML24 (see Section 3.3.6)
– A maximum of one IVML8 or IVML24 per system.
– Then install them in the slot beside the power supply in the basic cabinet or
the expansion cabinets.
– No SLC16N may be inserted in the PCM segment of the IVML8/IVML24.
– No SLMO24 may be inserted in the PCM segment of the IVML24.
– If a TMS2 is configured on the PCM segment of the IVML24, only a board
with a maximum of 8 ports may be inserted in the free slot.
●
SLMO24
A maximum of two SLMO24s per PCM segment; the number of connected sta-
tions (hosts (master)
and clients (slaves)) may not be more than 64.
Figure 4-90 PCM Segments for a One-Cabinet System
C
B
C
P
R
0
2 0
3 0
4 0
8 U
P
S
M
0
5 0
6 0
7
“8-slot” cabinets
BC