Siemens HiPath 3000 V3.0 or later Gigaset M1 Professional, Руководство по обслуживанию, Страница: 694 / 1202

Starting Up HiPath 3000
P31003-H3560-S403-54-7620, 09/05
5-16
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
start_h3.fm
Starting Up HiPath 3750 and HiPath 3700
Entering the country code starts the system. Any data that has already been stored, such as
system speed-dialing destinations and classes of service, is deleted or reset to the default val-
ue.
7. X You are prompted to select the password type:
1 = Variable password
2 = Fixed password
8. XX You are prompted to enter the country code (see Page A-
26). The system then boots up with the country-specific de-
fault information.
Notes:
●
On step 4 and step 5: If a new password is issued, both steps are omitted when calling
the system again.
●
On step 6: No country adjustment is necessary for Germany because the system starts
up with German codes.
●
On step 7: When selecting the fixed password, the default password (31994) overwrites
the new password entered under step 4.
7
For Brazil only: CO call privileges, ringback protection per trunk
If the system was initialized with the country code for Brazil, the option for saving the
digits dialed and transmitting them via the system (dial rule 1A) is not activated.
This can lead to dialing problems at DTMF terminals because the system waits for
the dial tone from the analog trunk and does not set up the connection between the
DTMF terminal and the trunk until it recognizes the dial tone. Digits dialed before dial
tone recognition are therefore not recognized by the CO. This in turn can impact CO
call privileges.
To avoid this, Least Cost Routing LCR should be activated for all systems with the
country code for Brazil and with connection to analog trunks with DTMF signaling.
>
After you enter a country code, the default data is only guaranteed to load correctly
if the system software has been officially released for that country.
Table 5-7 Entering the Country Code and Selecting the Password Type
Step Entry Description