Siemens HiPath 3000 V3.0 or later Gigaset M1 Professional, Руководство по обслуживанию, Страница: 62 / 1202

System Data
P31003-H3560-S403-54-7620, 09/05
2-28
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
sysdat.fm
Dynamic Configuration Rules
2.6.2 MOH Channels (G.711, G.723, G.729)
A DSP channel is reserved on an HG 1500 board for each codec used for MOH. Up to five co-
decs can be configured for MOH for every HG 1500 board.
Examples:
●
Only the codec G.711 is used for MOH: –> 1 DSP channel is needed.
●
Codecs G.711, G.723.1, and G.729AB are used for MOH: –> 3 DSP channels are needed.
The DSP channels needed for MOH are no longer available for voice connections.
MOH can be simultaneously supplied to a maximum of ten IP workpoint clients per HG 1500
board, irrespective of the number of codecs configured. This means that up to ten MOH data
streams are possible for each HG 1500 board. If more than ten MOH data streams are needed
simultaneously, MOH should be activated on other HG 1500 boards.
HiPath 5000 with HiPath ComScendo Service uses the MOH resources of the gateways logged
on, as described above.
The B channels used for MOH (DSP channels) are not licensed.
2.6.3 IP Networking Channels (PBX Networking Channels)
IP networking channels are used for connections between communication systems. In this
case, a distinction must be made between connections that use a gateway channel and direct
payload connections. Depending on the connection, the following resources are required for
successful connection setup.
A connection request is rejected if a required resource is unavailable.
HiPath 3000 Manager E is used to define how many of the maximum number of lines are to be
configured as IP networking channels (IP network trunks). The maximum number of IP network
trunks can be found in Table 2-7.
Connection type Line Gateway channel
Direct payload connection Required Not required
Gateway connection Required Required