Mitsubishi Electric MR-J4W2-0303B6, Инструкция по эксплуатации

Страница: 34 / 588

2. INSTALLATION
2 - 3
2.2 Keep out foreign materials
(1) When drilling in the cabinet, prevent drill chips and wire fragments from entering the servo amplifier.
(2) Prevent oil, water, metallic dust, etc. from entering the servo amplifier through openings in the cabinet or
a cooling fan installed on the ceiling.
(3) When installing the cabinet in a place where toxic gas, dirt and dust exist, conduct an air purge (force
clean air into the cabinet from outside to make the internal pressure higher than the external pressure) to
prevent such materials from entering the cabinet.
2.3 Encoder cable stress
(1) The way of clamping the cable must be fully examined so that bending stress and cable's own weight
stress are not applied to the cable connection.
(2) For use in any application where the servo motor moves, fix the cables (for the encoder, power supply,
and brake) with having some slack from the connector connection part of the servo motor to avoid
putting stress on the connector connection part. Use the optional encoder cable within the bending life
range. Use the power supply and brake wiring cables within the bending life of the cables.
(3) Avoid any probability that the cable insulator might be cut by sharp chips, rubbed by a machine corner or
stamped by workers or vehicles.
(4) For the cable installation on a machine where the servo motor moves, the bending radius should be
made as large as possible. Refer to section 10.4 for the bending life.
2.4 SSCNET III cable laying
SSCNET III cable is made from optical fiber. If optical fiber is added a power such as a major shock, lateral
pressure, haul, sudden bending or twist, its inside distorts or breaks, and optical transmission will not be
available. Especially, as optical fiber for MR-J3BUS_M/MR-J3BUS_M-A is made of synthetic resin, it melts
down if being left near the fire or high temperature. Therefore, do not make it touched the part, which can
become hot, such as heat sink or regenerative option of servo amplifier.
Read described item in this section carefully and handle it with caution.
(1) Minimum bend radius
Make sure to lay the cable with greater radius than the minimum bend radius. Do not press the cable to
edges of equipment or others. For the SSCNET III cable, the appropriate length should be selected with
due consideration for the dimensions and arrangement of the servo amplifier. When closing the door of
cabinet, pay careful attention for avoiding the case that SSCNET III cable is held down by the door and
the cable bend becomes smaller than the minimum bend radius. For the minimum bend radius, refer to
section 11.1.2.