Kubota G18, Руководство оператора, Страница: 80 / 206

62
ENGLISH
ADJUSTING THE PARALLEL LINKAGE
3
CAUTION
To avoid personal injury:
¡ ¡
¡ ¡
¡
Shut off the engine and remove the key.
¡ ¡ ¡ ¡ ¡
Set parking brake.
¡ ¡ ¡ ¡ ¡
Allow the blades to stop before making
adjustments.
¡ ¡ ¡ ¡ ¡
Blades may be sharp, when you handle
blades, wear heavy gloves or wrap end
of blade with rag.
1. Park the machine on a level surface.
2. Make sure the mower blades are level. Then
tighten the lock nuts securely.
Adjust
L
of front links with lock nut so that A is
0~5mm.
A=
Y
–
X
ADJUSTING THE MOWER DECK
(SIDE-TO-SIDE)
3
CAUTION
To avoid personal injury:
¡ ¡
¡ ¡ ¡
Shut off the engine and remove the key.
¡ ¡ ¡ ¡ ¡
Set parking brake.
¡ ¡ ¡ ¡ ¡
Allow the blades to stop before making
adjustments.
¡ ¡
¡ ¡ ¡
Blades may be sharp. When you handle
blades, wear heavy gloves or wrap end
of blade with a rag.
1. Park the machine on a level surface.
2. Tire inflation pressure must be correct.
(See “TIRE” section.)
3. Raise the hydraulic lift lever to the top position.
Turn the cutting height control dial to adjust
height to the desired height.
4. Lower the mower deck by pushing the hydraulic
lift lever forward.
5. Turn the left blade so that it is parallel to rear axle.
Hold drive belt and the turn right blade so that it is
parallel to axle.
6. Measure from each outside blade tip (L) and (R) to
the level surface. The difference between
measurements should be less than 3mm.