
82
ENGLISH
4.
Ensure the vent caps are securely in place. (if
equipped)
5.
Cover vent holes with damp rags. Do not allow
the rag to touch the battery terminals.
6.
Attach the red clamp to the positive (red,
2
or
pos.) terminal of the dead battery and clamp the
other end of the same cable to the positive (red,
2
or pos.) terminal of the helper battery.
7.
Clamp the other cable to the negative (black,
1
or
neg.) terminal of the helper battery.
8.
Clamp the other end to the engine block or frame
of the disabled machine as far from the dead
battery as possible.
9.
Start the helper vehicle and let its engine run for a
few moments. Start the disabled machine.
10. Disconnect the jumper cables in the exact reverse
order of attachment (steps 8, 7 and 6).
11. Remove and discard the damp rags.
(1) Dead battery
(2) Lay a damp rag over open vents
(3) Jumper cables
(4) Engine block or frame
(5) Helper battery
Connect cables in numerical order.
Disconnect in reverse order after use.
IMPORTANT:
¡
This machine has a 12 volt negative
1
ground
starting system.
¡
Use only same voltage for jump starting.
¡
Use of a higher voltage source on machine
electrical system could result in severe damage to
machine electrical system.
Use only matching voltage source when “Jump
starting” a low or dead battery condition.
Содержание G18
