Kubota G18, Руководство оператора, Страница: 185 / 206

167
ENGLISH
STORAGE
3
CAUTION
To avoid personal injury:
¡ ¡
¡ ¡ ¡
To reduce fire hazards, allow the engine
and exhaust system to cool before
storing the machine in an enclosed
space or near combustible materials.
¡ ¡
¡ ¡
¡
To avoid the danger of exhaust fume
poisoning, do not operate the engine in
a closed building without proper
ventilation.
¡ ¡
¡ ¡ ¡
Do not clean the machine with engine
running.
¡ ¡ ¡ ¡ ¡
To avoid fire hazards, Do not leave grass
and leaves in the mower and the grass
catcher.
¡ ¡
¡ ¡
¡
When storing, remove the key from the
key switch to avoid operation by
unauthorized persons.
When the machine will not be operated for over two
months, clean the machine and perform the following
operations before storage.
1.
Repair parts as necessary.
2. Check bolts and nuts and tighten as necessary.
3. Apply grease or engine oil to parts most likely to
rust.
4. Inflate the tires to a little above the standard
pressure levels. (Approximately 110%)
5. Lower the mower to the ground.
6. Remove the battery from the machine, recharge
it, adjust the electrolyte to the proper level, and
store in a cool dry place.
The battery discharges over time even while in
storage. Recharge it once a month in hot seasons
and once every two months in cold seasons.
7. Drain fuel tank, fuel lines.
8. Store the machine where it is dry and sheltered
from rain. Cover the machine with a tarpaulin.
9. Moisture content in most grasses can damage the
mower and grass catcher if these components are
not properly cleaned after use.
Make sure the mower and the grass catcher are
clean and completly empty before storage.
REMOVING THE MOWER FROM STORAGE
1. Check the tire inflation pressure and adjust as
required.
2. Install the battery. Before installing the battery, be
sure it is fully charged.
3. Do daily checking. (See “DAILY CHECK”.)
4. Check all fluid levels. (engine oil, hydrostatic oil)
5. Start the engine. Shut the engine off and walk
around tractor and make a visual inspection
looking for evidence of oil or other fluids.
6. Run engine a couple of minutes before you put
engine under load.
7. With the engine fully warmed up, release the
parking brake and test the brakes for proper
adjustment as you move forward. Adjust the
brakes as necessary.