Hioki 3504-40 C HiTester, Инструкция по эксплуатации

Страница: 170 / 292

8.7 Message List
164
Measurement Value Memory Function
:MEMory?
No Data/ ALL Query of measurement values saved to mem-
ory by the measurement value memory func-
tion
*1,2,6
231
:MEMory:CLEar Deleting data from memory of measurement
value memory function
*2 232
:MEMory:COUNt? Query of number of measurement values
saved to memory by the measurement value
memory function
*1, 2 232
:MEMory:CONTrol
ON/ IN/ OFF Setting of measurement value memory func-
tion
*2, 3
233
:MEMory:CONTrol?
Query of measurement value memory func-
tion
*1, 2
233
:MEMory:POINts
1 to 32000 Setting of memory size for measurement val-
ue memory function
*2, 3
234
:MEMory:POINts?
Query of memory size for measurement value
memory function
*1, 2
234
Monitor
:MONItor?
Query of voltage and current monitor levels *1, 2
234
:MONItor:DISPlay
ON/ OFF Setting of voltage and current monitor value
display
*2, 3
235
:MONItor:DISPlay?
Query of voltage and current monitor value
display
*1, 2
235
Initialize Device
:PRESet
Initialize Device *2
235
Measurement Range
:RANGe
1 to 10 (NR1) Setting of measurement range *2, 3
236
:RANGe?
Query of measurement range *1, 2
236
:RANGe:AUTO
ON/ OFF Automatic setting of measurement range *2,3,5
237
Unique Commands
Command Data Section Explanation
Error
Refer-
ence
Page
Error Explanations (An error is generated when a message is executed in the following cases)
*1 Query Error _______ When a response message exceeds 10 kB
*2 Execution Error ____ When a command is executed while open circuit, short circuit, or load compensation
*3 Execution Error ____ When set to other than the specified character data or numeric data.
*4 Execution Error ____When a number that has not been saved is specified.
*5 Execution Error ____When a command is executed during comparator measurement or BIN measure-
ment.
*6 Execution Error ____When not even one measurement value is saved to memory.
*7 Execution Error ____When there is an RS-232C specific command or query while the interface type is set
to GP-IB.
*8 Execution Error ____When a command to display a reference value in the SUB display area is executed
while the count setting is configured.
Note: Command errors are generated for all messages with a misspelling.