Hioki 3504-40 C HiTester, Инструкция по эксплуатации

Страница: 204 / 292

8.9 Message Reference
198
Note About Recovering Compensation Values
When the :CORRection:OPEN RETurn is carried out, disabled open
circuit compensation values can be retrieved, but when open circuit
compensation is carried out again after the circuit compensation val-
ues are disabled, the pre-disabled open values cannot be retrieved.
Refer to the following examples.
Example of a retrievable circuit compensation value.
Example of a non-retrievable circuit compensation value.
Setting and Query of Open Circuit Compensation Function
A. When open circuit compensation is carried out under the points in
the figure below.

:
adjustment value valid

:
no adjustment value
120 Hz 1 kHz
0.1 V (Model 3504-60 only)
 
0.5 V


1 V


frequency
Measurement signal
level
B. The following will occur when circuit compensation is dis-
abled (execute :CORREction:OPEN OFF), or when
is pressed for 2 seconds or more.
 :
adjustment value invalid

:
no adjustment value
120 Hz 1 kHz
0.1 V (Model 3504-60 only)  
0.5 V


1 V


frequency
Measurement signal
level
C. When CORRection:OPEN RETurn is executed, setting
before circuit compensation disabled will return.
a. When open circuit compensation is carried out at whichever point
from B. (the following shows an example when :CORRection
:OPEN ON is carried out in 1 kHz, level: 0.5)

:
adjustment value valid

:
no adjustment value
120 Hz 1 kHz
0.1 V (Model 3504-60 only)
 
0.5 V


1 V
 
frequency
Measurement signal
level
b. When CORRection:OPEN RETurn is executed in a., the
device will remain in a. condition (in order to retrieve a new
circuit compensation value)