Fluke 6135A/PMU, Руководство оператора

Страница: 15 / 160

Introduction and Specifications
Components of the Calibration System
1
1-11
Server PC
The Server PC (shown in Figure 1-5) is a server computer that receives commands from
the Client PC and controls the Calibration System. The default settings made by Fluke at
the time of shipping are:
•
PC name:
PMUCal
•
ID Address:
192.168.0.250
Network administrators can set up IP addresses to configure the Server PC to work on the
network if necessary, but take note of the cautions listed below. To work on the Server
PC, plug in a monitor, a mouse, and a keyboard into the Input Panel.
W
Caution
To prevent damage to the Calibration System:
•
Only use the Server PC for Calibration System operation.
•
Anti-virus programs can disrupt or block Server/Client
communications. Installation of these programs on the
Server PC should be avoided if possible.
•
Do not enable Windows automatic updates. The automatic
updates feature can force a PC reboot at any time which
could occur while the system is in operation. Periodically
check for updates and perform a manual update.
•
The Server PC should use a fixed IP address (static) and not
use auto-allocation (dynamic).
•
Do not change the configuration of the Server PC.
When more than one Calibration System is connected to the same network, the IP
addresses and Server PC names of at least one system must be changed so that each
system has unique identification.
The Server PC connections are available at the Input/Output Panel on the side of the
cabinet. See Table 1-5 .