Fluke 6135A/PMU, Руководство оператора

Страница: 68 / 160

6135A/PMU
Operators Manual
3-26
Result File Save Options
After connected to the UUT or the simulator, the result file selection window (see
Figure 4-18) automatically opens. The results file selection window supplies you with
three buttons to choose where to save the test results.
Note
Each time a test is completed, the maximum test parameter values overwrite
the existing values in the results file until a new results file is made or
selected.
Each button will save the test results as follows:
•
If
Start a New Results File
(the green button) is clicked, the PMUCal Software
makes a new results file. The button shows where the file is to be saved and also the
name of the results file.
•
If
Continue Using
(the yellow button) is clicked, the Calibration Software uses the
last results file that test results were saved to. If a results file was not previously used
or the UUT has never been tested before, the button will be disabled and no link will
be shown in the path. The button shows where the file is to be saved and also the name
of the results file.
•
If
Browse and Select an Existing Results File
(the red button) is clicked, the
PMUCal Software opens an Windows Load dialog box to navigate to and select a
results file.
Note
To prevent mixing test results from another UUT personality and
configuration, make sure the correct file is chosen.
gtu080.jpg
Figure 3-25. Results File Selection Window
Results File Storage Directory
After the initial installation of the PMUCal Software, it is necessary to choose where to
make the top-level folder named
Fluke PMUCal
. Once made, the folder will contain a
folder named “results”. The results folder is the storage location for all results files.
Figure 3-26 illustrates the folder structure.
Note
After installation of the Calibration Software, the location of the top-level
PMUCal folder or the results folder can be changed (see “Set Up the File
Storage Directory” in Chapter 2).