Fluke 6135A/PMU, Руководство оператора

Страница: 78 / 160

6135A/PMU
Operators Manual
4-8
UUT Data Cable Connection
Connect the network Ethernet cable from the Calibration System Input/Output Panel to
the UUT as follows (refer to Figure 4-4):
1.
On the rear panel of the Server PC, put one end of the
Ethernet Cable
into the left
most
Ethernet Port
(see Figure 4-4).
2. On the rear panel of the UUT, put the other end of the
Ethernet Cable
into the
PMU
Ethernet Port
.
Input/Output Panel
To the UU T To the Client PC or Local Network
gtu141.emf
Figure 4-4. The UUT and Server PC Network Cable Connections
GPS Signal Cable Connection
Connect the GPS timing signal cable from the Calibration System Input/Output Panel to
the UUT as follows (refer to Figure 4-5):
Note
Some UUTs have internal GPS receivers with a GPS Antenna input. On
these, connect the antenna input to the GPS Antenna Out on the Calibrator.
For other UUTs, connect the IRIG-B input to the IRIG-B Out of the
Calibrator.
1. On the UUT, connect the
Coax Cable
to the applicable
GPS Input
.
The Calibrator
has a GPS Antenna Output, an IRIG-B Output, and/or a PPS Output.
Note
Some UUTs that use a IRIG-B input must have a PPS input signal
connected. Refer to the UUT user documentation for more information.
2. On the Calibrator, connect the
Coax Cable
to the
IRIG-B, GPS, or PPS Timing
Signal Output
.
Input/Output Panel
IRIG-B Input
UUT
gtu142.emf
Figure 4-5. Example GPS IRIG-B Connection