Fluke 6135A/PMU, Руководство оператора

Страница: 109 / 160

General Testing
Test Configuration Instructions
6
6-7
Test Type Parameter
The test type parameter is type of test that the test file is configured for. Select a Steady
State, Frequency Ramp, Modulation, or Step Test (see “Standard Compliance Tests and
Subtests” in Chapter 4). The test type parameter tells the PMUCal Software which test
parameters in the test file to use when a test is run or simulated.
gtu124.emf
Figure 6-1. Test Type Selection
When the test configuration window is first opened, the test type defaults to Steady State.
If a different test file is loaded, the test type changes to the test type saved in the test file.
To change the test type, click on the test type selection drop-down box on the top of the
window or click on the test type selection buttons (see Table 6-1 and Figure 6-1).
Note
When a test is run, the calibration software only runs and reads the test
parameters for the test shown in the test type combo box.
Test Parameters
The test parameters settings set the test parameters for each test type. Use the subsequent
sections to set the test parameters for each test type.