Fluke 6135A/PMU, Руководство оператора

Страница: 81 / 160

UUT Calibration Setup
Communicate with the UUT
4
4-11
Set Up a UUT Personality Profile
A UUT personality profile is a file that stores unique information about the UUT (refer to
“UUT and Simulator Personality Profiles” in Chapter 3). The UUT personality profile
contains information such as the UUT IP address, port number, ID, and the phasor order.
Each time a connection is made to the UUT, a UUT personality profile must be loaded or
made. Immediately after you click
Continue
on the start menu window, the UUT
Personality Configuration Screen opens (see Table 4-2).
A saved UUT personality profile can be updated or changed after you have configured
the connection. To change a UUT personality profile, click
Settings
in the main
navigation menu and then click
Edit PMU Personality
.
To set up a UUT Personality Profile (refer to Table 4-2):
1.
Use the start menu window to connect to the Server PC. The UUT personality
window opens automatically after a connection is made.
2. Click
Load
to load a UUT personality profile or make a new UUT personality
profile. To make a new UUT personality profile (refer to Table 4-2):
a.
Type in the
Manufacturer
,
Model
,
Identifier,
and
Serial Number
.
b. Select the
Connection Type
.
c. Type in
192.92.92.92 for the UUT
IP address (the UUT IP address was
configured previously, see “Prepare the UUT for Calibration” in this Chapter).
d. Type in the
Port
of the UUT (
4712
is the default UUT port).
e. Choose the
ID
number of the UUT.
f. Chose the
Version
of C37.118.2 communications protocol in use by the UUT.
g. Select
PMU Class
(M-Class or P-Class).
h. Type in
Nominal Voltage
.
i. Type in
Nominal Current
.
j. Enter
Voltage Input Ratio
.
k. Enter
Current Input Ratio
.
l. Type in
Settling Period
.
3. Click
Save
to save the file for future use (if desired).
4. Click
Connect to UUT and Get PMU Config
to continue. If successful, a message
dialog box opens that says “Connected to PMU. Please verify the Phase Order”.
Click
OK
to open the Phase Order Configuration tab.
5. Configure the UUT Phase Order. See the next section.