Fluke 6135A/PMU, Руководство оператора

Страница: 113 / 160

General Testing
Test Configuration Instructions
6
6-11
Note
The Start and End Frequencies are affected by Transition Time setting.
Modulation Test Parameters
A Modulation test is a dynamic test that tests UUT response to cosine modulated phase,
amplitude, or both. (see “Standard Compliance Tests and Test Files” in Chapter 3 for
more information). See Table 6-6 for a detailed description of each Modulation test
parameter.
To configure a Modulation test (refer to Table 6-6):
1.
Set the
General Test Parameters
. (refer to “General Test Parameters” in this
section).
2. Click
Modulation Tests
.
3. Set the
Modulation Test Parameters
as follows:
a. Set the
Input Frequency
.
b. Set the
Phase Shift
.
c. Set the
Phase Modulation Frequency
.
d. Set the
Phase Modulation Index
.
e. Set the
Amplitude Modulation Frequency
.
f. Set the
Amplitude Modulation Index
.
g. Set the
Settling Time
.
4. Click
Save
to save the test (if desired).
5. Run the test. Refer to the instructions in “Run a Custom Interactive Test” in this
chapter.