Fluke 6135A/PMU, Руководство оператора

Страница: 117 / 160

General Testing
Run a Single Test
6
6-15
Table 6-7. Latency Test Configuration Window
gtu180.emf
Item Field Name Description

Test Duration
The Test Duration in seconds. The duration should
be long enough to collect a sufficient number of
measurements.
Measurement Latency Test Parameters
To configure a Measurement Latency Test (refer to Table 6-7).
1.
Click
Latency Test
.
2. Set
Test Duration
.
3. Click on
Save
to save the test (if desired).
4. Run the test. Refer to the instructions in "Run a Custom Interactive Test" in this
chapter.
Note
Interactive Latency test cannot be simulated and is not available when the
Calibration System is in simulation mode.
Run a Single Test
1. Prepare the UUT for test and calibration (use the instructions in Chapter 4).
2. Click
Test
in the top
Navigation Menu
.
3. In
Interactive Testing
, click
Run Single Test
. A Windows Load dialog box
opens.
4. Load a test file as follows:
a.
Navigate to the test file in the test folder.
b. Select the test file.
c. Click
OK
.
5. After the test is complete, configure the plot configuration window (refer to “Make
an Interactive Plot” in Chapter 7).