Fluke 6135A/PMU, Руководство оператора

Страница: 79 / 160

UUT Calibration Setup
Communicate with the UUT
4
4-9
Communicate with the UUT
To set up communications with the UUT, the Calibration System must be installed and
configured (refer to “Install the Calibration System” in Chapter 2). To communicate with
the UUT, a UUT personality profile must be configured which includes the UUT phase
order. Follow the instructions in the subsequent sections to set up UUT communications.
To communicate with the UUT (refer to Table 4-1):
1.
Open the PMUCal Software. When the Calibration Software opens, the startup menu
shown in Table 4-1 automatically opens.
2. On the Startup menu, select the
PMU Test Mode
for the Mode of Operation. For
information on PMU Test Mode and Simulation Mode, see “PMUCal Software
Modes of Operation” in Chapter 4.
3. Type in the Server IP address or Server PC name into the server address field. See
Table 4-1 for more information on the Server Network Address selections. The
default Server PC settings as supplied by Fluke are: IP address:
192.168.0.250
and
PC name:
PMUCal
4. Select the check box to the left of
Show Tool Tips
to turn on helpful program
tooltips (optional).
5. Click
Store as Default
to store the current settings as default settings to use these
settings the next time you connect.
6. Click
Continue
to connect to the Server PC.
If a connection to the Server PC is successful, a PMU personality profile dialog opens. If
the connection is not successful, a warning dialog box opens.
If a connection cannot be made after two attempts, refer to “Network” in Chapter 8.