Fluke 6135A/PMU, Руководство оператора

Страница: 105 / 160

General Testing
About this Chapter
6
6-3
About this Chapter
This chapter supplies instructions on how to do an interactive test on a UUT. To do the
procedures in this chapter, the UUT must be connected and configured. If the UUT is not
connected and configured, refer to “Prepare the UUT for Calibration” in Chapter 4.
For an alphabetical list of terms and abbreviations used in this chapter and manual, see
“The Glossary” in Appendix A of this manual.
General Testing
Custom interactive testing lets an operator make a single test, simulate or run it on a
UUT, then interactively plot the results. The test parameters can be saved for to be used
later.
When
Customize and Run Single Test
is clicked, the test configuration window
shown in Table 6-1 opens. The test configuration window is the test creation and
management interface used to make or change a single test. See Table 6-1.
When
Run Single Test
is clicked, a test of the operators choice is opened, run, and
interactively graphed.
To run a custom interactive test refer to “Run a Custom Interactive Test” in this section.
To configure the custom interactive test, refer to “Test Configuration Instructions”.
Note
Test parameters cannot be edited in general testing. To edit the parameters
of a test, use custom testing.
The test configuration window is the test creation and management interface to make or
change a single test. Table 6-1 shows and describes the different areas of the test
configuration window.