Yamaha RCX141, User Manual

Page: 89 / 402

4-
31
4
Operation
9. “AUTO” mode
When the program “_SELECT” exists:
1) Press the
F 1
(RESET) key in “AUTO” mode.
The following message appears on the guideline when “_SELECT” exists among
the programs. Press the
F 4
(YES) key to reset the selected program by
switching it to “_SELECT”, or press the
F 5
(NO) key to just reset the current
program.
Fig. 4-9-7 Program reset
AUTO [T1] 50% <TEST1 >
1 *ST:
2 MOVE P, P0
3 MOVE P, P1
4 MOVE P, P2
5 GOTO *ST
Change to _SELECT OK? YES NO
2) When the
F 5
(NO) key is pressed in Step 1), the following message then
appears on the guideline.
Press the
F 4
(YES) key to reset the current program, or press the
F 5
(NO)
key to cancel the reset.
Fig. 4-9-8 Program reset
AUTO [T1] 50% <TEST1 >
1 *ST:
2 MOVE P, P0
3 MOVE P, P1
4 MOVE P, P2
5 GOTO *ST
Reset program OK? YES NO
n
NOTE
The output is also reset when the
program is reset. However, the output
will not be reset when a sequence
program is being executed without
selecting “RST.DO” in the sequencer
execution “ENABLE/DISABLE” flag
setting.