Still RX60 35-50, Original Instructions Manual

Page: 545 / 596

Pneumatic tyres (variant)
–
Check the tread depth on all four tyres.
The tread depth for pneumatic tyres (variant)
must be at least 1.6 mm at every point on the
tread. If the tread is worn down to the wear
mark (2) at any point on the tyre, replace the
tyres on one axle.
If the truck is to be used in winter conditions in
areas where the StVZO (German Road Traf-
fic Licensing Regulations) applies, the profile
must be at least 4 mm.
–
Remove any foreign bodies embedded in
the tyres.
Checking the air pressure
NOTE
The correct air pressure for pneumatic tyres
(variant) is determined by the type of tyre
used. The air pressure measured must corre-
spond to the manufacturer's information.
–
Observe the air pressure value on the ad-
hesive label on the truck; see the "labelling
points".
–
Check the air pressure of all four tyres and
compare with the air pressure values stated
on the adhesive labels.
–
Add or release air as required if the air
pressure deviates from the values stated.
6331_003-006
3

Maintenance
5
Preserving operational readiness
529 56388011501 EN - 05/2022 - 08