Still RX60 35-50, Original Instructions Manual

Page: 277 / 596

End lift cut-out (variant)
This assistance system limits the lift height of
the fork carriage.
This assistance system does not release the
driver from the obligation to observe the
"Safety regulations for handling loads".
The end lift cut-out is active by default when
the truck is switched on. The symbol ap-
pears in the display. It can be switched off if
required. When the truck is switched on again,
it is active again.
NOTE
Check the lift heights set here before use via
the
End lift cut-out
menu.
Switching off the end lift cut-out
–
Stop the truck.
–
Apply the parking brake.
–
Press the button.
The first menu level appears.
–
Press the softkey.
–
Press the softkey.
The symbol goes out. The end lift cut-out
is switched off.
–
To switch the end lift cut-out on again,
press the softkey again.
NOTE
The maximum lift height cannot be modified
by the driver. It can be changed either by the
authorised service centre or with the "Access
authorisation for the fleet manager" via the
display-operating unit.
Configuration by the fleet manager
–
Activate the "Access authorisation for the
fleet manager".
–
Press the button.
–
Press the softkey.

Operating
4
Lift height-dependent assistance systems
261 56388011501 EN - 05/2022 - 08