Still RX60 35-50, Original Instructions Manual

Page: 237 / 596

DANGER
There is a risk of fatal injury from a falling load or
fork!
–
Tighten the locking screw (2) each time a fork is
changed.
–
It is not permitted to drive or to transport loads
without the locking screw in place.
NOTE
If the truck is equipped with the "load meas-
urement" assistance system (variant), the
"tare" function must always be run after the
fork arms have been changed. Otherwise, cor-
rect load measurement cannot be guaranteed.
Fork extension (variant)
DANGER
There is a risk of fatal injury from being run over if
the truck rolls away.
–
Do not park the truck on a gradient.
–
Apply the parking brake.
–
Change the fork extension in a cordoned-off, safe
location on a level surface.
WARNING
There is a risk of injury!
There is a risk of crushing due to the weight of the
fork extension. There is a risk of cutting on sharp
edges or burrs.
–
Wear protective gloves and safety shoes.
WARNING
There is a risk of tipping!
The weight and dimensions of the fork extension af-
fect the stability of the truck. The permissible weights
stated on the capacity rating plate must be reduced
in proportion to the actual load distance.
If the truck is equipped with a fork extension ex
works, then the capacity rating plate will already
have been adjusted accordingly.
–
Observe the load capacity; see the section enti-
tled "Capacity rating plate" in the chapter entitled
"Handling loads".
Operating
4
Lifting
221 56388011501 EN - 05/2022 - 08