Still RX60 35-50, Original Instructions Manual

Page: 234 / 596

–
If the load programs are saved as a favour-
ite on a softkey, press the softkey until
the number of the desired load program is
shown on the display.
The number of dynamic bar segments shows
the load dynamics of the selected load pro-
gram.
Limiting the load dynamics to load program 1
during the warm-up phase
NOTE
During the warm-up phase, the load dynamics
are limited to load program 1. The adjacent
symbol appears on the display until the warm-
up phase is complete.
–
Refer to the section entitled "Warming up
the hydraulic oil at cold ambient tempera-
tures" in the chapter entitled "Operation —
Checks and tasks before daily use."
Fork wear protection (variant)
The "fork wear protection" variant ensures that
the fork arms do not touch the ground. The
fork arms are protected against wear and the
building floor is protected against damage.
There are two types of fork wear protection:
●
Fork wear protection (mechanical)
This variant is described here.
●
Electrical fork wear protection
The fleet manager can configure this var-
iant. See the section "Electrical fork wear

6219_003-312

Operating
4
Lifting
218 56388011501 EN - 05/2022 - 08