Still RX60 35-50, Original Instructions Manual

Page: 296 / 596

Dynamic Load Control 1 regulates the lifting
and tilting dynamics and the driving dynamics
according to the following criteria:
●
Lift height
●
Load weight
Load movements which could lead to critical
conditions are slowed down if necessary.
Dynamic Load Control 1 intervenes in the fol-
lowing operating situations:
●
With a telescopic lift mast:
The fork carriage is at least 2.1 m off the
ground.
●
With a triple mast:
The fork carriage is in the second lifting
stage
●
The load picked up exceeds 50% of the
nominal load
The driving speed is reduced to 5 km/h at a
lift height of 2.1 m and higher or in the second
lifting stage.
NOTE
When the fork carriage has been lowered be-
low the lift heights mentioned above, the driver
can deactivate the speed restriction again. Re-
lease the accelerator pedal for a short period
to do this.
If a sensor belonging to Dynamic Load Con-
trol 1 fails, the level of intervention from the
function is increased to a maximum.
Dynamic Load Control 2 (var-
iant)
WARNING
Risk of accident as a result of overloading!
"Dynamic Load Control 2" is not a safety function
and does not release the driver from the duty to
observe the information specified in the load capacity
diagram!
Operating
4
Load-dependant assistance systems
280 56388011501 EN - 05/2022 - 08