Still RX60 35-50, Original Instructions Manual

Page: 385 / 596

–
Fully lower the fork carriage before driving
any further.
–
Depending on the variant, switch off the la-
ser. Manual: Press the softkey again to
switch off the laser. Automatic: The laser
switches off automatically if:
●
The "lift/lower" function is not actuated for
20 seconds
●
The truck is travelling faster than 4 km/h
●
The laser is switched off using the softkey
in the display-operating unit
Adjusting the laser
The laser must project an exactly horizontal
line so that the lift height of the fork can be ac-
curately estimated. Therefore, the laser must
be regularly checked to ensure that it is exact-
ly horizontal.
–
Safely park the truck opposite a horizontal
reference object, e.g. the horizontal base of
a rack.
–
Switch on the laser and lift the fork to the
height of the reference object. The laser line
must run exactly parallel to the reference
object.
If the line is not parallel, proceed as follows:
–
Loosen the four grub screws (1) on the cov-
er plate (2) and carefully remove the cover
plate.
–
Loosen the grub screw (3) that prevents
the laser from rotating by turning the grub
screw anti-clockwise.
–
Carefully rotate the laser until the laser line
is parallel to the reference object again.
–
Carefully tighten the grub screw (3) by turn-
ing it clockwise.
–
Re-fit the cover plate (2) on the mainte-
nance opening and tighten the four grub
screws (1).
Cleaning the lens of the laser
To ensure that the system operates accurate-
ly, the lens of the laser must be clean and
free of ice. If the laser line is no longer clearly
visible, the lens must be cleaned.

Operating
4
Optical assistance systems
369 56388011501 EN - 05/2022 - 08