Still RX60 35-50, Original Instructions Manual

Page: 285 / 596

Electrical fork wear protection
(variant)
This assistance system, in conjunction with
the optical height measuring system, ensures
that the fork arms do not touch the ground.
The correct height for inserting the forks in a
pallet can also be configured. Since the fork
must always be lowered completely when the
truck is safely parked, the fork wear protec-
tion can also be temporarily suspended. See
the following section "Lowering the forks com-
pletely".
NOTE
The desired height of the fork wear protection
can be changed either by the authorised serv-
ice centre or with the "Access authorisation for
the fleet manager" via the display-operating
unit.
The fork wear protection function is always
active when the truck is switched on. The
"fork wear protection" symbol appears in
the display. Only the authorised service centre
may deactivate the function.
●
If the symbol is grey, the assistance
system is switched on.
●
If the symbol is black, the assistance
system is taking effect.
The fork carriage does not lower to a level
that is higher than the set level.
Lowering to the ground
NOTE
The fork wear protection cannot be switched
off permanently. The fork wear protection can
be temporarily deactivated to lower the fork
arms to the ground and securely park the
truck.
–
Lower the fork carriage until the fork wear
protection function intervenes.
–
Release the "lower" operating device.
The fork wear protection is switched off.
–
To lower the fork to the ground fully, acti-
vate the "lower" operating device again.
6219_003-232

Operating
4
Lift height-dependent assistance systems
269 56388011501 EN - 05/2022 - 08