![background image](http://html1.mh-extra.com/html/omron/sysmac-cj1w-scu21-v1/sysmac-cj1w-scu21-v1_operation-manual_743586215.webp)
186
Using Protocol Macros
Section 5-4
Example 1
Sequence
Error
Sequence ended
abnormally
Step No. 01
Error
Sequence ended
abnormally
Sequence ended
normally
Example 2
Sequence
Step No. 01
Step No. 02
Error
Sequence ended
abnormally
Sequence ended
normally
Sequence ended
normally
When the sequence ends normally
Sequence
executed
Sequence
completed
Sequence
re-executed
Protocol Macro
Executing Flag
Sequence End
Completion Flag
Step Error
Processing
Flag
Error processing
for step No. 00
Step Error
Processing
Flag
When the sequence ends normally
When the sequence ends abnormally
Sequence Abort
Completion Flag
When the sequence ends abnormally
Note
The Step Error Processing Flag is used to see whether error processing has been executed for
an individual step in a sequence, and not for the overall steps. Therefore, as shown in Example 2
above, after executing error processing during a sequence (step No. 00), the flag will remain ON,
even if the next step ends normally. Care is therefore required because it is not always possible
to use this flag to determine whether the overall sequence has ended abnormally.
Sequence
executed
Sequence
completed
Sequence
re-executed
Protocol Macro
Executing Flag
Sequence
executed
Sequence
completed
Sequence
re-executed
Protocol Macro
Executing Flag
Step Error
Processing
Flag
Sequence Abort
Completion Flag
Sequence
executed
Sequence
completed
Sequence
re-executed
Protocol Macro
Executing Flag
Step Error
Processing
Flag
Error processing
for step No. 00
Sequence End
Completion Flag
Step No. 00
Step No. 00
Error
Summary of Contents for SYSMAC CJ1W-SCU21-V1
