NetApp AFF A700, System Documentation

Page: 708 / 1672

b. Rotate the cam latch down until it is in a horizontal position.
The I/O module disengages from the chassis and moves about 1/2 inch out of the I/O slot.
c. Remove the I/O module from the chassis by pulling on the pull tabs on the sides of the module face.
Make sure that you keep track of which slot the I/O module was in.
Lettered and numbered I/O cam latch
I/O cam latch completely unlocked
4. Set the I/O module aside.
5. Install the replacement I/O module into the chassis by gently sliding the I/O module into the slot until the
lettered and numbered I/O cam latch begins to engage with the I/O cam pin, and then push the I/O cam
latch all the way up to lock the module in place.
6. Recable the I/O module, as needed.
Step 3: Reboot the controller after PCIe module replacement
After you replace a PCIe module, you must reboot the controller module.
Steps
1. If the node is at the LOADER prompt, boot the node, responding
y
if you see a prompt warning of a system
ID mismatch and asking to override the system ID:
bye
705