Molecular Devices ImageXpress Confocal HT.ai, User Manual

Page: 36 / 256

ImageXpress Confocal HT.ai High-Content Imaging System User Guide
36 5084773 A
Accessory Description
Bead Plate TetraSpeck fluorescent microspheres test plate
Bead Slide FocalCheck fluorescent microspheres test slide
Hex Keys 1/16 in.
0.05 in.
Slide Holder Single
Calibration Slides Spatial (GP-2)
Red (GP-7)
Green (GP-8)
Blue (GP-9)
Yellow (GP-11)
Shading Correction Plates Fluorescent Green
Fluorescent Red (red plate)
Fluorescent Red (pink plate)
Filter Tools Emission and Dichroic
Storage Box Accessory box for miscellaneous storage
Table 3-1: Accessory Kit Contents
If you need to re-install the MetaXpress software or install the software on a new computer,
see the
MetaXpress Installation and Update Guide included on the Molecular Devices
Knowledge Base at support.moleculardevices.com
Verifying Device Settings in the Meta Imaging Series Administrator Software
Use the Meta Imaging Series Administrator Software to configure all hardware and software
components. This section describes how to verify that the ImageXpress Confocal HT.ai system
hardware components are properly configured in the Meta Imaging Series Administrator
Software and in the MetaXpress software.
Note:
We recommend that you run verification tests without a sample plate loaded on the
stage except when verifying the Laser Autofocus Sensor.
You cannot simultaneously run the Meta Imaging Series Administrator Software and
the MetaXpress software.
To verify the hardware configuration:
1. Power on the instrument but do not start the MetaXpress software.
2. Click Start > MetaXpress 6 > Meta Imaging Series Administrator to display the Meta
Imaging Series Administrator.