imagistics ipc1- im8130, Administrator'S Manual

Page: 145 / 377

ipc1-im8130 Administrator’s Guide 123
Setting up a Wireless Network
Note: The Cisco Wi-Fi NIC does not support Extensible Authentication
Protocol (EAP).
Install the wireless NIC and press the
F
ACTORY
D
EFAULTS
button to
initialize the controller for both the wireless and embedded Ethernet
NICs.
The
WIRELESS
button on the copier LCD touch screen and the wireless
settings in Printer Utility are only visible when a Wireless NIC is installed.
The following instructions assume that the controller has been updated
with the latest version of the software.
User Interface Settings
The following table shows the user interface options for configuring
wireless networking from the copier control panel and the Administration
tab of the web-based Printer Utility.
Wireless Networking User Interface Options
UI Controls Type of Control Value Read Write
Control Panel Printer Utility
Data Rate Text Label in status
area of front panel Text label 11, 5.5, 2, 1 X
SSID Text field Text field up to 32 characters X X
Network Type Option button List box Infrastructure/Ad Hoc X X
WEP Security Option button Check box Enabled/Disabled X X
WEP Encryption Option button List box 40 Bits/ 128 Bits X X
WEP Key (40 bit) Text Field Text Field 5 * 2 hex characters X
WEP Key (128 bit) Text Field Text Field 13 * 2 hex characters X
Authentication Option buttons List box Open/Shared X X
Default Access
Point Text Field Text Field 6 * 2 hex
(Infrastructure) X X
Channel Text Field List box (Ad Hoc)
Text label
(Infrastructure) Numeric (1-11)
6 (2427 MHz)
X X
Data Retries Text Field Text Field Numeric (0-2312) X X
Fragment
Threshold Text Field Text Field Numeric (256-2312) X X
RTS Threshold Text Field Text Field Numeric (1-2312) X X
RTS Retry Limit Text Field Text Field Numeric (1-128) X X
Transmit Power Option buttons Combo 1, 5, 20, 30, 50, 100 X X
im6530, im8130