imagistics ipc1- im8130, Administrator'S Manual

Page: 120 / 377

98 ipc1-im8130 Administrator’s Guide
8 To set the controller as a master browser, click the
Master Browser
drop-
down list and select
Enable
. The default setting is
Disable
.
9 Click
Save
.
10 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Rebooting the
Controller on page 30.
Configuring AppleTalk Settings
If you are using the AppleTalk networking protocol for any network traffic
involving the controller, you must enable the AppleTalk protocol on the
controller. The AppleTalk protocol is enabled by default. If you are not
using AppleTalk for any network traffic, disabling the AppleTalk protocol
on the controller reduces overhead and improves efficiency.
1
Log in as an administrator.
2 On the Administration tab, click the
Setup
subtab.
3 Click the
Network
link. The Network page opens.
4 In the AppleTalk area, click the
Protocol
drop-down list.
5 Select
Enable
to enable AppleTalk. This is the default setting.
6 Enter the
AppleTalk Zone
string.
7 Click
Save
.
8 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Rebooting the
Controller on page 30.
Restoring Default Protocol Settings
You can restore the network settings to their default values. Restoring the
defaults returns the controller to the state it was in when it was delivered.
im6530, im8130