imagistics ipc1- im8130, Administrator'S Manual

Page: 121 / 377

ipc1-im8130 Administrator’s Guide 99
1 Log in as an administrator.
2 On the Administration tab, click the
Setup
subtab.
3 Click the
Network
link. The Network page opens.
4 Click
Restore Defaults
to restore the default settings.
5 Click
Yes
.
6 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Rebooting the
Controller on page 30.
Configuring Wireless Network Protocol
Properties
The
Administration > Setup > Wireless Network
page lets you set up the protocols
used by client workstations to communicate with the network through
the wireless NIC installed in the controller. You must configure the
wireless protocols before anyone can access the wireless network.
By default, all network protocols are enabled.
You must log in as an administrator to set wireless network protocol
properties.
Enabling/Disabling the Wireless Card
If you are using the wireless network for any network traffic involving the
controller, you must enable the wireless NIC on the controller. The
wireless NIC is enabled by default. If you are not using the wireless
network for any network traffic, disabling the wireless NIC on the
controller reduces overhead and improves efficiency.
im6530, im8130