imagistics ipc1- im8130, Administrator'S Manual

Page: 119 / 377

ipc1-im8130 Administrator’s Guide 97
controller. The TCP/IP protocol is enabled by default. If you are not using
TCP/IP for any network traffic, disabling the TCP/IP protocol on the
controller reduces overhead and improves efficiency.
1
Log in as an administrator.
2 On the Administration tab, click the
Setup
subtab.
3 Click the
Network
link. The Network page opens.
4 In the TCP/IP area, click the
IP Address Resolution
drop-down list.
5 Select either
Static IP
or
DHCP
. The default setting is
DHCP
.
Note: If DHCP is selected, the
IP Address
,
Subnet Mask
, and
Gateway
fields
are not displayed.
6 Enter the
IP Address
,
Subnet Mask
, and
Gateway Address
if appropriate.
7 Enter the address of the
Primary DNS Server
.
8 Enter the address of a
Secondary DNS Server
.
9 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Rebooting the
Controller on page 30.
Configuring SMB Settings
If you are using the SMB networking protocol for any network traffic
involving the controller, you must enable the SMB protocol on the
controller. The SMB protocol is disabled by default. If you are not using
SMB for any network traffic, disabling the SMB protocol on the controller
reduces overhead and improves efficiency.
1
Log in as an administrator.
2 In the SMB area of the Network page, click the
Protocol
drop-down list.
3 Select
Enable
to enable SMB protocol. This is the default setting.
4 In the
Device Name
field, enter the controller name.
5 Enter the controller
Workgroup
in the appropriate field.
6 Enter the address of the
Primary WINS Server
.
7 Enter a
WINS Scope ID
for the controller.
Note: Macintosh and Unix networks must have WINS or NETBIOS
support to access the ipc1-im8130 controller by name instead of IP
address.
im6530, im8130