Hioki 3155-01, Instruction Manual

Page: 293 / 366

273
────────────────────────────────────────────────────
8.8.2 Commands
────────────────────────────────────────────────────
Example Transmission
:MEMory:READ:MEASure? 1,EARTh
Response Headers ON :MEMORY:READ:M2.345E‑03,0,0,0,1,0,
+2.456E‑03,0,0,1,1,0,+2.510E‑03,0,0,2,1,0
Headers OFF +2.345E‑03,0,0,0,1,0,+2.456E‑03,0,0,1,1,0,
+2.510E‑03,0,0,2,1,0
The saved data of earth leakage current of the data unit 1 are as follows.
Maximum value Judgment Power source polarity Condition of the equipment Filter
Measurement current to be measured
2.345 mA PASS Normal polarity Normal condition ON
AC+DC
2.456 mA PASS
Normal polarity Single fault condition ON
AC+DC (open power lead)
2.510 mA PASS Normal polarity Single fault condition ON
AC+DC (open ground)
Error (ME equipment) (ordinary equipment)
If the data unit number exceeding the total number of data units is set, an
error occurs
■ Saves the maximum value.
Syntax :MEMory:SAVE
Function
Saves in memory the maximum value of the current measuring mode, and
the set-up condition and the model name and number of the equipment to
be measured when measuring the maximum value.
Note Use this command only after using the ":MODE" command to set the
measuring mode.
Example Transmission
:MEMory:SAVE
Error (ME equipment) (ordinary equipment)
If the measuring mode has not been set, an error occurs.
If there is insufficient memory available, an error occurs.
:MEMory:SAVE