Hioki 3155-01, Instruction Manual

Page: 285 / 366

265
────────────────────────────────────────────────────
8.8.2 Commands
────────────────────────────────────────────────────
■
Queries the maximum values after automatic measurement.
Syntax :MEASure:AUTO?_< data>
Function Returns the measurement results collectively.
Returns the maximum values of the combinations of the power source
polarity and condition of the equipment to be measured, their judgments,
power source polarities, and conditions of the equipment to be measured, as
numerical values in NR3 and NR1 format.
The data are ordered as follows: <
maximum value>, < judgment>, <
power source polarity> and < condition of the equipment to be
measured>, and the available combination of the automatic measurement is
read in a format of
to .
<Judgment>
(If the allowable value judgment is disabled, 0)
Allowable value or lower (PASS): 0
Higher than allowable value (FAIL): 1
<Power source polarity>
(If the equipment to be measured is set to the internally powered
equipment, 0)
Normal polarity: 0
Reverse polarity: 1
<Condition of the equipment to be measured>
Normal condition: 0
Single fault condition (open power lead): 1
Single fault condition (open ground): 2
Single fault condition (110% voltage applied): 3
Note
Execute this command after verifying that the automatic measurement is
finished (:AMC? command). Executing this command during automatic
measurement will not obtain the correct result.
Use this command only after using the ":MODE" command to set the
measuring mode.
:MEASure:AUTO?