Hioki 3155-01, Instruction Manual

Page: 112 / 366

92
────────────────────────────────────────────────────
5.10 Condition Set-up Window Setting (ME Equipment)
────────────────────────────────────────────────────
NOTE
(2) Press the normal or fault key to select the desired allowable value.
(3) Using the numerical keys, input the desired value. (After pressing the
numerals key) Press the key to clear mistakes.
(4) After the numeric value is input correctly, press either unit key to finalize
the input. If the screen is changed before the unit is finalized, the setting
is not revised. The unit keys are inoperative until a numeral has been
input.
(5) After making the setting, press the key to close the allowable value
set-up window.
(6) The allowable value judgment can be turned ON or OFF on the allowable
value judgment set-up screen of the system screen. If set to OFF, the
allowable values are not displayed on the measuring mode screen.
・ To apply a coefficient to a value that is already input, press the key,
and input the coefficient with the numeric keys. Next, press the key
to finalize the setting.
If the screen is changed before the unit is finalized, the setting is not
revised.
・ The maximum value is cleared after the setting is revised.
・ Because 110% voltage is applied in normal condition in the enclosure
leakage current measurement mode, set the allowable value in normal
condition again.
・ The numeral is initialized but the coefficient is not after the settings on the
equipment set-up screen are changed.