Hioki 3155-01, Instruction Manual

Page: 111 / 366

91
────────────────────────────────────────────────────
5.10 Condition Set-up Window Setting (ME Equipment)
────────────────────────────────────────────────────
5.10.1 Allowable Value Setting (For Leakage Current
Measurement)
Screen during input of the value in normal
condition
(Numerals are displayed in the input cell.)
Set value = numeral
×
coefficient
Range: 5
μ
A to 20 mA
NOTE
5.10 Condition Set-up Window Setting (ME Equipment)
The allowable value setting may be revised as necessary to accommodate the
measuring mode and condition of the equipment to be measured (normal
condition or single fault condition).
The 3155 can set two allowable values in normal condition and single fault
condition.
When shipped, the allowable values are set in accordance with IEC 60601-1
(1988-12) + am1 (1991-11) + am2 (1995-03).
For details, refer to Section 10.4.2, "Default Settings."
Settings
(1) On the measuring mode screen, press the key to open the
allowable value set-up window.
Current setting
Input numeral
Input coefficient
Keys for numerical input
Normal: Press to set the allowable value in normal condition
Fault: Press to set the allowable value in single fault condition
Numerals: Press to input numerals
Coefficient: Press to input coefficient
Units: Highlighted in white during numerical input. Press after numerical
input to finalize units.
Return: Press to close the allowable value set-up window.
If a value of less than 5 μ A is input, the value is automatically revised to
5 μ A. If a value of more than 20 mA is input, the value is automatically
revised to 20 mA.