Hioki 3155-01, Instruction Manual

Page: 271 / 366

251
────────────────────────────────────────────────────
8.8.2 Commands
────────────────────────────────────────────────────
■
Sets the condition of the equipment to be measured in the manual measurement.
Syntax
:CONFigure:CONDition_< data>
data NORMal/EARTh/POWersource
Function Sets the condition of the equipment to be measured in the manual
measurement.
NORMal Normal condition.
EARTh Single fault condition (open ground)
POWersource Single fault condition (open power lead)
Note
The setting cannot be made depending on the the condition of the
equipment to be measured setting and measuring mode.
For details, refer to the table below.
Use this command only after using the ":MODE" command to set the
measuring mode.
Example Transmission
:CONFigure:AUTO OFF;
:CONFigure:CONDition NORMal
The condition of the equipment to be measured is set to the nomal
condition.
Error
(ME equipment) (ordinary equipment)
If the measuring mode has not been set, or when in the low resistance
measurement mode, or when in automatic measurement mode, or if the
setting cannot be made in the current condition, an error occurs.
Condition of the
equipment to be
measured
Measuring mode
Class equipment Class equipment Internally powered
equipment
N.C S.F.C N.C S.F.C N.C S.F.C
Open
power
lead
Open
ground
Open
power
lead
Open
ground
Open
power
lead
Open
ground
Earth leakage current Yes Yes No − − − − − −
Enclosure leakage current Yes Yes Yes Yes Yes No Yes No No
Low resistance measurement − − − − − − − − −
Patient auxiliary current Yes Yes Yes Yes Yes No Yes No No
Patient leakage current Yes Yes Yes Yes Yes No Yes No No
Patient leakage current No No No No No No No No No
Patient leakage current No No No No No No No No No
:CONFigure:CONDition
Conditions available by the "CONFigure:CONDition" command
N.C: Normal condition
S.F.C: Single fault condition