Hioki 3155-01, Instruction Manual

Page: 177 / 366

157
────────────────────────────────────────────────────
6.6 Condition Set-up Window Setting (for IEC/TR 60990)
────────────────────────────────────────────────────
Start measurement
Measurement
(normal polarity, open power lead)
Measurement
(normal polarity, open ground)
Measurement
(normal polarity, normal condition)
Measurement
(reverse polarity, open power lead)
Finish measurement
Measurement
(reverse polarity, open ground)
Measurement
(reverse polarity, normal condition)
Standby
Standby
Standby
Standby
Standby
Standby
NOTE
(5) On the measuring mode screen, press the
key to start automatic measurement. When the
measurement of a particular condition is finished,
if it exceeds the current maximum value, the
maximum value is revised to the new value.
During measurements, the key is displayed.
Press the key to interrupt the measuring
process. After the measurements have been
completed, the key is displayed.
During the measuring time, the beeper sounds.
(6) After the measurements have been completed, the
automatic measurement result screen opens.
Example: Enclosure leakage current measurement
Automatic measurements are carried out in the following order:
Polarity: normal, then reverse
Status: open power lead, open ground, normal condition
A part of the single fault condition is omitted according to the grounding class
setting.
Categories to be set prior to automatic measurement
・ Filter ON or OFF for all the measuring modes
・ Contact condition
・ Measurement current
It is necessary to have set the above categories manually prior to performing
automatic measurement.