Hioki 3155-01, Instruction Manual

Page: 131 / 366

111
────────────────────────────────────────────────────
5.11 System Screen (ME Equipment)
────────────────────────────────────────────────────
5.11.4 Allowable Value Judgment Set-up Screen
NOTE
5.11.5 Beep Sound Set-up Screen
Setting the allowable value judgment (comparison with the
maximum value and current value)
: Perform the allowable value judgment. If the
maximum value and current value are less than or
equal to the allowable value, PASS is displayed, if
higher than the allowable value, FAIL. Also, the
allowable value beep sound setting becomes effective.
: Do not perform the allowable value judgment.
The allowable values are not shown on the
measuring mode screen.
Setting the beep sound for the allowable value judgment
: If the allowable value judgment for the maximum
value is FAIL, the beep sound is emitted.
: The beep sound is not emitted for the allowable value
judgment.
: Return to the system screen.
If the key is pressed, the beep sound
stops.
Turn the beeper on or off.
: Turn the beeper on
: Turn the beeper off
If the beep sound has been set to ON, it will be emitted under
the following conditions, and the beep sound setting for the
allowable value judgment become effective as well.
The beep sound is emitted when:
・ The power is turned on.
・
A key is pressed.
・ Making a measurement in the automatic measurement mode.
・
An input of 25 mA or more is detected in the leakage current
measurement mode.
The beep sound is emitted irrespective of the beep sound setting
when:
An error has occurred in the RS-232C system.