Hioki 3155-01, Instruction Manual

Page: 288 / 366

268
────────────────────────────────────────────────────
8.8.2 Commands
────────────────────────────────────────────────────
■ Queries the line voltage monitored parameter.
Syntax :MEASure:VOLTage?
Function
Returns the line voltage monitored parameter as a 4-digit numerical value
in NR3 format.
Note
Use this command only after using the ":MODE" command to set the
measuring mode.
Example
Transmission :MEASure:VOLTage?
Response Headers ON
:MEASURE:V99.90E+00
Headers OFF
+99.90E+00
The line voltage monitored parameter is 99.9 V.
Error (ME equipment) (ordinary equipment)
If the measuring mode has not been set, or when in the low resistance
measurement mode, an error occurs.
■
Queries the measured value.
Syntax
:MEASure?
Function
Returns the measured value and its judgment as numerical values in NR3
and NR1 format.
The data are ordered as follows: <measured value> and <judgment>.
<Judgment>
(If the allowable value judgment is disabled, 0)
Allowable value or lower (PASS): 0
Higher than allowable value (FAIL): 1
Note
Use this command only after using the ":MODE" command to set the
measuring mode.
Example
Transmission :MEASure?
Response Headers ON
:M2.345E‑03,1
Headers OFF
+2.345E‑03,1
The measured value is 2.345 mA, and the allowable value judgment is
"higher than allowable value (FAIL)."
Error
(ME equipment) (ordinary equipment)
If the measuring mode has not been set, an error occurs.
:MEASure:VOLTage?
:MEASure?