7-90
Cisco TelePresence System Release 1.6 Administration Guide
OL-13676-04
Chapter 7 Troubleshooting the CTS 1300
Managing Hardware Setup
Figure 7-82
Measuring and Installing the Seat Alignment Guides
Step 8
Place another piece of tape 18 inches (46 cm) from the edge of the table where the participants sit to
form a tape cross on the table.
Step 9
Remove the seat alignment guides and (if required) anchors from their packaging in carton 14.
Step 10
Place the seat alignment guides on each of the crosses on the table. See
Figure 7-82
for more
information.
Step 11
Arrange the seat alignment guides so that the line on top of the guides point directly toward the camera.
Step 12
Fasten the guides to the table using one of the following methods:
•
Remove the adhesive backing from the underside of the guide and stick it to the table, making sure
that the line on the guide points directly at the camera.
•
Attach the seat alignment guide anchor to the table, and place the guide on the anchor, by completing
the following steps:
a.
Using a 1/4-inch drill bit, drill a 1.125 inch deep hole into the center of each tape cross.
b.
Remove the tape.
c.
Screw the seat alignment guide anchor into the hole that you drilled, using the key that is
included with the anchor.
206544
2
3
4
5
11
10
9
8
1
12
6
7
Field of view
center camera
Field of view
left camera
18 inches
(46 cm)
Field of view
right camera
18 inches
(46 cm)
18 inches
(46 cm)
18 inches
(46 cm)
