7-31
Cisco TelePresence System Release 1.6 Administration Guide
OL-13676-04
Chapter 7 Troubleshooting the CTS 1300
Managing Hardware Setup
Step 3
Click Show Focus Targets.
Step 4
Position the small camera target by completing the following steps:
a.
Place the target on the table one foot from the edge where the participants sit.
b.
Position the target so that the patterns on the target are enclosed in the green box.
Step 5
Position the large target by completing the following steps:
a.
Remove the large focus target from the easel.
b.
Rotate the target 90 degrees.
c.
Have another person hold the target upright.
Note
If another person is not available, clamp the top of the target into the clamp at the top of the easel.
d.
Place the top of the easel five feet behind the top of the small target.
e.
Position the target so that the topmost patterns are enclosed in the red box.
Figure 7-26
shows large and small target positions.
Figure 7-26
Positioning the Small and Large Targets
Step 6
Adjust the focus on the left camera by completing the following steps:
a.
Loosen the thumbscrew for the lens focus ring.
b.
Twist the focus ring clockwise until the red and green horizontal bars on the bottom of the screen
are reduced to very short lengths on the left.
Note
Figure 7-26
shows a mirror image of the horizontal bars.
c.
Twist the focus ring counter-clockwise until the red and green bars extend all the way to the right.
d.
Continue to twist the focus ring until the red and green bars are approximately the same length. See
Figure 7-26
to view the approximate horizontal bar alignment. When the bars are roughly the same
length, the camera is focused.
206146
Red
rectangle
Green
rectangle
Large
target
Small
target
Red and green
horizontal bars
