7-63
Cisco TelePresence System Release 1.6 Administration Guide
OL-13676-04
Chapter 7 Troubleshooting the CTS 1300
Managing Hardware Setup
Step 6
Adjust the camera mounting plate to center the red plus sign on the display inside the black plus sign on
the target.
The screws that you use to adjust the camera are shown in
Figure 7-59
.
•
The top two screws provide adjustment to the right and left. Use a 2.5 mm Allen wrench for these
screws.
•
The lower screw provides up and down adjustment. Use a 2.5 mm Allen wrench for this screw.
•
The screws in the middle adjust the camera rotation. Use a 3 mm Allen wrench for these screws.
Figure 7-59
Camera Adjustment Screws
Step 7
Adjust the camera zoom by completing the following steps:
a.
Loosen the thumbscrew for the zoom ring on the camera lens.
Note
The zoom ring is labeled “W-T”.
b.
Align and center the camera by competing the following steps:
•
Align the black curved line on the right of the target until it touches the right side of the display
screen.
•
Center the black cross on the target with the red cross on the display screen.
c.
After you adjust the zoom, make any required adjustments to the focus with the focus ring.
Right
adjust
screw
Left
adjust
screw
Up/down
adjust
screw
Side to side
adjust screw
Side to side
adjust screw
Up/down
adjust
screw
206130
