6-23
Cisco TelePresence System Release 1.5 Administrator Guide
OL-13676-04
Chapter 6 Troubleshooting the CTS 1100
Managing Hardware Setup
Step 4
Click Start to begin the test.
The test pattern should display on the external presentation display.
Step 5
Click Stop to end the testing.
Testing Presentation Devices
The output for presentations is handled by projectors, or
LED
s. Input to the projector can be delivered
through a Video Graphics Array (
VGA
) input device (such as a laptop computer) or through a document
camera.
Note
You should run this test only if you have presentation display devices installed.
Table 6-6
contains supported presentation devices listed by system.
The projector is set up successfully when the test pattern is displayed on the projection surface in the
meeting room while running the test.
Tip
When troubleshooting presentation devices, start with the projector test pattern to see if the projector is
set up correctly and then proceed through VGA and document camera input tests as necessary.
Use the information in the following sections to test presentation devices:
•
Checking the Test Pattern, page 6-24
•
Checking the VGA, page 6-24
•
Checking the Document Camera, page 6-25
•
Resetting the Projector, page 6-25
•
Troubleshooting Presentation Devices, page 6-25
•
Related Information, page 6-22
Table 6-6
Supported Presentation Devices
Presentation Device
Included in Cisco TelePresence System
—
Optional in Cisco TelePresence System
•
CTS 1100
Projector
Document Camera
—
•
CTS 1100
