5-7
Cisco TelePresence System Release 1.6 Administration Guide
OL-13676-05
Chapter 5 Troubleshooting the CTS 1000
Managing Hardware Setup
Removing the Camera Hood
Removing the camera hood provides access to the zoom and focus rings for the camera. To remove the
camera hood, follow these steps:
Step 1
Find the two screw holes in the bottom of the camera hood and unscrew the two M4 x 10 mm screws.
Step 2
Remove the hood from the camera.
Assembling and Setting Up the Camera Targets
The Cisco TelePresence System uses targets to set focus and camera alignment and to help with color
balance. Two targets are used. This section describes how to assemble and set up the camera targets.
To assemble and set up the camera targets, follow these steps:
Step 1
Carefully open the box containing the two targets and the target frame components. The frame elements
are in the bottom of the box.
Note
Take care not to damage the box. When you are finished with the camera adjustment procedure, you can
disassemble and store the target in the box for future use.
Step 2
Lay the two metal frames on the floor.
Step 3
Attach the two frame pieces with the screws.
Step 4
Locate the horizontal center point in the Cisco TelePresence System 1000 frame and mark the
corresponding point on the table.
Step 5
Attach the camera target frame to the table by tightening the clamps to the table edge, as shown in
Figure 5-2
. The target should be attached on the side of the table where the participants sit and the target
should be facing the camera.
Tip
The edge of the table should be 4 to 8 feet (1.2 to 2.4 meters) from the camera.
