7-40
Cisco TelePresence System Release 1.6 Administration Guide
OL-13676-04
Chapter 7 Troubleshooting the CTS 1300
Managing Hardware Setup
Figure 7-35
Placement of Easel and Target for Small Racetrack Table
Step 2
In the Cisco TelePresence Administration window, click the Right radio button.
Step 3
Click Show Camera Target.
Step 4
Focus the right camera by completing the following steps:
a.
Loosen the focus ring thumbscrew on the lens of the center camera.
b.
Rotate the focus ring until the black plus sign (+) on the target is clearly in focus.
Note
The camera lens has two adjustment rings, one for focus and one for zoom, as shown in
Figure 7-36
. The focus ring is the one that is nearest to the wall.
Figure 7-36
Location of Focus and Zoom Ring
Step 5
Adjust the camera mounting plate to center the red plus sign (
+
) on the display inside the black plus sign
(+) on the target.
The screws that you use to adjust the camera are shown in
Figure 7-37
. Use a 2.5 mm Allen wrench.
Display
206162
Right participant
sitting position
camera target
Alignment
marker
Focus ring
Zoom ring
206131
